Coolbreeze Fluidmaster Float Valve M240 Series

This genuine Coolbreeze Fluidmaster float valve is a direct replacement part designed to keep your M240 Mobile 2002-02 E Series evaporative cooler running smoothly.

In Australian conditions, a reliable float valve is critical to maintain correct water levels, preventing dry-outs or overflows that can damage your unit or waste water, especially during a hot summer. I've seen too many evaporative coolers leak or seize up because of a faulty float valve. Swapping out a worn one is a quick fix that saves a lot of hassle down the track.

Best For

• Evaporative cooler service techs
• Maintenance teams
• Competent DIY owners working on Coolbreeze units

Compatibility

• Coolbreeze M240 Mobile 2002-02 E Series evaporative coolers
• Replaces Coolbreeze Part Number: SP2027

If you're running a different model, check fittings and specs before ordering.

Features

• Genuine Coolbreeze replacement part for trusted performance.
• Designed specifically for the M240 Mobile 2002-02 E Series.
• Ensures consistent and accurate water level control in your cooler.
• Helps prevent costly water damage or pump dry-outs.

What's in the Box

• One (1) Coolbreeze Fluidmaster Float Valve, Part No. CBSP2027

Using It on the Job

1. Isolate power to the evaporative cooler at the main switchboard and apply lockout procedures.
2. Drain the cooler tank completely and clean out any accumulated sludge or debris.
3. Disconnect the old float valve, carefully noting its orientation and connections.
4. Install the new Coolbreeze Fluidmaster Float Valve (CBSP2027), ensuring all connections are secure and leak-free.
5. Re-establish power and test the unit, checking for proper water fill, shut-off operation, and no overflows.
6. Visually inspect for any leaks around the new valve and throughout the tank area before completing the job.

Limitations & Safety Notes

• Only compatible with the specified Coolbreeze M240 Mobile 2002-02 E Series units.
• Always isolate electrical power before performing any maintenance or repair work on evaporative coolers.
• Ensure installation is carried out by a competent person in adherence to Australian standards.
• Check for leaks thoroughly after installation to prevent water damage to the unit or property.

Tradie Pro Tip

Before installing, always give the cooler tank a good clean-out. Even a small bit of gunk can foul up a new float valve quickly. A clean tank means a happy cooler.

Pair With

Pair with Coolbreeze filter pads and a new drain valve to complete your evaporative cooler's preventative maintenance, ensuring it runs efficiently through the season.