Brivis Gas Valve CSX Javelin Honeywell VR8215S1206

This genuine Honeywell VR8215S1206 gas valve is a direct replacement for your Brivis CSX Javelin ducted heater, ensuring your heating system runs safely and efficiently. A faulty gas valve can lead to unreliable ignition or complete system shutdown, leaving households cold on a chilly Aussie night.

Getting the right part is crucial, especially when it comes to gas components. This valve is specifically designed for natural gas (NG) applications in compatible Brivis models, helping you get the job done right the first time.

Best For

• HVAC technicians servicing Brivis CSX Javelin ducted gas heaters.
• Property maintenance teams replacing failed gas valves.
• Competent DIY owners maintaining their Brivis CSX Javelin system.

Compatibility

This gas valve is engineered as a direct replacement for:

• Brivis CSX Javelin ducted gas heaters.
• It is configured for Natural Gas (NG) applications.
• Replaces Brivis PN: 80024708, B024708.
• Corresponds to Honeywell VR8215S1206.

If you're running a different model, check fittings and specs before ordering.

Features

• Genuine Honeywell Valve: Reliable Javelin CSX series for consistent performance.
• Natural Gas (NG) Ready: Specifically configured for standard natural gas supplies.
• Direct OEM Replacement: Matches Brivis Part Numbers 80024708 and B024708.
• Exact Fit: Designed for straightforward installation into Brivis CSX Javelin units.

What's in the Box

• 1 x Brivis Gas Valve CSX Javelin Honeywell VR8215S1206 (BS80024708)

Using It on the Job

1. Isolate Power & Gas: Before starting any work, ensure the electrical supply to the heater is switched off at the mains and the main gas supply valve is closed.
2. Verify Depressurisation: Ensure any residual gas pressure is safely vented or purged before disconnecting fittings.
3. Remove Old Valve: Carefully disconnect gas lines and electrical connections from the existing valve. Note wiring positions.
4. Install New Valve: Mount the new Honeywell valve in place, connect gas lines using appropriate thread sealant (rated for gas), and re-attach electrical wiring.
5. Leak Check: Open the main gas supply, then use an approved leak detection solution on all new connections to check for leaks. Look for bubbles forming.
6. Test Operation: Restore power and test the heater's ignition sequence to ensure the new gas valve functions correctly.

Limitations & Safety Notes

• Installation and servicing of gas appliances must be performed by a licensed gas fitter in Australia, as per local regulations.
• This valve is for Natural Gas (NG) only. Do NOT attempt to use it with LPG or other fuel types.
• Always follow the heater manufacturer's installation guidelines and Safe Work Australia practices.
• Only use this part for the Brivis CSX Javelin series or other models explicitly stated by the manufacturer to be compatible with Honeywell VR8215S1206.

Tradie Pro Tip: When replacing a gas valve, it's good practice to also inspect the ignitor and flame sensor. Small issues with these components can often mimic gas valve problems, and replacing them at the same time can prevent a call-back.

Pair With

Complete your repair or service with gas leak detectors and quality gas-rated thread sealant. You might also consider other Brivis Heating spares like ignitors and pressure switches to ensure your heater runs perfectly.