Bonaire Inner Seal for Aquamiser Mk2 Drain Valve

This Bonaire Inner Seal is a genuine replacement part designed for your Aquamiser Mk2 drain valve. It's crucial for keeping your evaporative cooler running efficiently, preventing leaks and unnecessary water waste.

When you're up on a hot Aussie roof servicing an evap cooler, a good seal means less call-back work, and this one is made to fit right.

Best For

• Evaporative cooler service technicians
• HVAC apprentices and maintenance teams
• Competent DIY homeowners maintaining their own Bonaire units

Compatibility

This seal is specifically designed for Bonaire Aquamiser Mk2 drain valves. It is a direct replacement for Bonaire part number 6050197SP. If you're running a different model, check fittings and specs before ordering.

Features

• Genuine Bonaire replacement part for assured fit and performance.
• Constructed from durable white rubber suitable for water immersion.
• Helps maintain correct water level and prevents leaks from the drain valve.
• Corresponds to Bonaire PN 6050197SP for straightforward part identification.

What's in the Box

• 1 x Bonaire Inner Seal for Aquamiser Mk2 (White Rubber)

Using It on the Job

1. Always isolate power to the evaporative cooler at the mains before commencing any work.
2. Drain the water from the cooler reservoir completely.
3. Carefully remove the existing drain valve assembly, paying attention to how the old seal was seated.
4. Clean any debris or mineral build-up from the drain valve housing to ensure a proper seal.
5. Install the new white inner seal, making sure it sits correctly and forms a tight fit.
6. Reassemble the drain valve and perform a water fill and leak test before restoring power to the unit.

Limitations & Safety Notes

• Ensure all power is isolated before working on evaporative coolers to prevent electrical hazards.
• Always drain water fully to avoid slips or electrical hazards during maintenance.
• This seal is only for use with the specified Bonaire Aquamiser Mk2 drain valve.
• Dispose of old parts responsibly according to local regulations.

Before you slap that new seal in, give the drain valve seat a good clean with some fine wet-and-dry sandpaper or even a bit of Scotch-Brite. Any grit or scale left behind will chew up your new seal quick smart, and you'll be back on the roof sooner than you'd like.

Pair With

Pair with Bonaire float valves and evaporative cooler filter pads for a complete system maintenance approach.