This Fasco JRM38 evaporative cooler pump is a genuine replacement part, built tough for Australian conditions. It’s designed to keep your Bonaire or Climate Technologies evaporative cooler running smoothly, making sure you’ve got reliable water flow when the mercury climbs.
When your cooler pump packs it in during a 40-degree summer day, you need a swap-out that fits right and gets the air moving again without a fuss. This unit comes with the integrated side mounting bracket, ready for a straightforward install.
Best For
- Replacement in Bonaire evaporative coolers.
- Maintenance teams for residential and light commercial evaporative cooling systems.
- DIY owners undertaking routine evaporative cooler servicing.
Compatibility
The Fasco JRM38 pump with side mounting bracket is specifically engineered to suit Bonaire evaporative cooler air conditioners. It's also known by the Climate Technologies part number 6050812SP. If you're running a different model, check fittings and specs before ordering.
Features
- Integrated Side Mounting Bracket: Designed for direct replacement in compatible Bonaire units.
- Splash Proof Cover: Provides protection in the damp conditions of an evaporative cooler reservoir.
- Continuous S1 Duty Rated: Built to run constantly for extended periods without overheating.
- Auto Reset Over Temperature Protection: Safely shuts down the pump if it gets too hot, then restarts when cool.
- Stainless Steel Shaft: Resists corrosion for a longer service life in water environments.
- Quiet Running: Engineered for proven reliability and low operational noise.
Technical Specifications
| Specification | Detail |
|---|---|
| Model | JRM38 |
| Part Number | 6050812SP |
| Voltage | 240V AC, 50Hz |
| Nominal Power | 50 Watts |
| Maximum Flow | 40 litres per minute |
| Maximum Head | 3,000mm |
| Flow at 600mm Head | 29.5 litres per minute |
| Flow at 1600mm Head | 16.5 litres per minute |
| Weight | 2.30 KGS |
What's in the Box
- 1 x Fasco Replacement Evaporative Cooler Pump JRM38
- Integrated Side Mounting Bracket
- Climate Technologies Part Number: 6050812SP
Using It on the Job
- Isolate Power: Always ensure the evaporative cooler’s main power is switched off and locked out before any work begins.
- Drain System: Safely drain the water reservoir and remove any old water distribution components.
- Remove Old Pump: Disconnect the wiring and any water lines from the old pump. Unbolt or unclip it from its mounting.
- Install New Pump: Position the Fasco JRM38 in place using the integrated side mounting bracket. Connect the water outlet hose and electrical wiring. Double-check all connections are secure.
- Test Operation: Refill the reservoir and restore power. Verify the pump is running quietly and circulating water effectively to the pads. Check for any leaks.
- Post-Service Check: Ensure the cooler fan operates correctly and the cooler is distributing air evenly before leaving the site.
Limitations & Safety Notes
- This pump is designed for evaporative cooler applications only; do not use for pressurised water systems.
- Always ensure power is isolated before installing or servicing any electrical components.
- Confirm the JRM38 model is the correct replacement for your specific cooler model by checking your existing pump or manufacturer documentation.
- Follow all manufacturer installation guidelines and local electrical safety standards during replacement.
Tradie Pro Tip
Before you even order, pull out your old pump and confirm it's a JRM38 with that side bracket. Sometimes wiring connections can vary slightly between models or years, so be ready to adapt where needed – a quick wiring check saves a second call-out.
Pair With
Pair with replacement evaporative cooler filter pads and a quality cooler cleaning solution to give your whole system a proper refresh while you’re swapping out the pump. We stock a full range of evaporative cooler parts to keep you covered.