If you're upgrading or replacing a control board on an older Brivis ducted gas heater, you know the headaches of mismatched connections. This Brivis Heater Loom Conversion helps bridge that gap, making the swap from an EMS control system to a HCCA621 Classic Board much smoother.
It's designed to save you time and hassle, cutting out the need for complex wire splicing on a hot Australian rooftop install or in a tight cupboard.
Best For
- HVAC technicians performing Brivis heater service or upgrades.
- Apprentices learning ducted gas heater control systems.
- Service teams maintaining Brivis ducted gas heating units.
- Competent DIY owners comfortable with electrical work on their Brivis heater.
Compatibility
This conversion loom is specifically designed for Brivis ducted gas heaters that require a wiring conversion from an existing EMS (Electronic Management System) control setup to a HCCA621 Classic Control Board. It's a direct fit for Brivis PN: 80008882.
If you're running a different model or a different control board, check fittings and specs before ordering.
Features
- Genuine Brivis OEM part, ensuring a reliable fit and performance.
- Converts existing EMS wiring to seamlessly suit the HCCA621 Classic Control Board.
- Simplifies control board upgrades or replacements, reducing installation time.
- Assists in maintaining optimal heater operation and safety standards.
- Features Brivis Part Number 80008882 for easy identification and matching.
What's in the Box
- 1 x Brivis Heater Loom Conversion EMS to HCCA621 (Part No. BS80008882)
Using It on the Job
- Always isolate all power to the Brivis ducted gas heater at the main switchboard and apply lockout/tagout procedures before starting work.
- Confirm the existing control system is EMS and the new or replacement board is an HCCA621 Classic Board to ensure the correct loom application.
- Carefully disconnect the old loom from the EMS system and the various heater components (e.g., fan, ignitor, gas valve). Document connections with photos if unsure.
- Connect the new conversion loom to the HCCA621 Classic Board and then to the heater's corresponding components, ensuring all connections are secure and correctly seated.
- Double-check all wiring against the heater's electrical schematic before restoring power and testing the unit.
- Conduct a full operational check of the heater, including ignition, fan operation, and verification of all safety limits.
Limitations & Safety Notes
- Always isolate power and ensure proper lockout/tagout procedures are followed before working on any electrical components.
- This loom is only for converting Brivis EMS wiring to HCCA621 Classic Board compatibility; it will not work for other control board types or brands.
- Installation involving electrical connections should always be performed by a qualified and licensed technician in Australia.
- Follow all manufacturer instructions and relevant Australian electrical safety standards and Safe Work guidance during installation and testing.
Before you even unbox this loom, take a few clear photos of your existing wiring setup. It's a lifesaver if you get wires crossed or just need to double-check a connection point during the swap.
Pair With
Pair with a new Brivis HCCA621 control board and other Brivis Heating spares for a complete system overhaul. Don't forget your multimeter for diagnostics and testing after installation.