This Brivis flame sensor (BS80024831) is a critical component for keeping older Brivis gas heaters running safely and efficiently. If a heater's acting up and not firing consistently, a faulty flame sensor is often the culprit, and swapping one out is a common fix you'll do on a chilly morning call-out. It helps ensure reliable ignition and flame detection, preventing nuisance lockouts.
This genuine Brivis part provides an accurate signal to the control board, letting it know the burner has lit correctly, which is essential for safe operation.
Best For
- HVAC service technicians working on ducted gas heaters.
- Refrigeration apprentices learning gas heating diagnostics.
- Competent DIY homeowners maintaining their own Brivis systems.
Compatibility
This Brivis Igniter Flame Sensor with a Spade CSX connection is specifically designed to suit Brivis Compact Classic units. It is a direct replacement for Brivis Part Numbers 80024831 and B024831. If you're running a different model, check fittings and specs before ordering.
Features
- Genuine Brivis replacement part ensures reliable performance and fit.
- Spade CSX connection for straightforward and secure wiring.
- Designed for accurate flame detection within compatible Brivis gas heating systems.
- Helps prevent nuisance faults and ensures safe burner operation by confirming ignition.
What's in the Box
- 1x Brivis Gas Heater Flame Sensor Spade CSX (BS80024831)
Using It on the Job
- Always isolate power to the gas heating unit at the main switchboard and perform a lockout procedure before starting any work.
- Shut off the main gas supply to the appliance for safety.
- Locate the existing flame sensor, typically positioned near the burner assembly.
- Carefully disconnect the wiring and remove the old sensor, noting its exact orientation.
- Install the new Brivis flame sensor, ensuring a secure fit and correct wiring connection to the spade terminal.
- Restore gas and power, then test the heater's ignition sequence multiple times to confirm proper operation and safe shutdown.
Limitations & Safety Notes
- Installation and servicing of gas appliances must only be performed by a licensed gas fitter in accordance with Australian standards (AS/NZS 5601).
- This component is designed for specific Brivis Compact Classic units; always confirm compatibility with your heater model before installation.
- Always verify proper gas pressure and venting after any component replacement.
- Do not attempt repairs if you are unsure about gas or electrical safety procedures.
Before condemning the control board for an intermittent ignition fault, always give the flame sensor a good clean or replace it. A dirty or weak sensor is a common culprit and an easy, cost-effective fix that often gets a customer's heating back online quickly.
Pair With
Pair with Brivis control boards or Brivis pressure switches if you're doing a full system diagnostic. Don't forget your digital manometer for checking gas pressures.