This Brivis flame backup sensor is an essential spare for maintaining the reliable operation of Brivis gas heaters, ensuring your system runs safely through the colder months. When a flame sensor starts playing up, you get nuisance lockouts, and that's the last thing you need on a cold morning call-out.
Specifically designed for Brivis MPS models, this 500mm sensor helps the control board confirm ignition and maintain the flame, preventing gas leaks and ensuring efficient heating.
Best For
- HVAC service technicians working on Brivis gas heaters.
- Apprentices learning gas appliance fault finding.
- Competent DIY owners maintaining specific Brivis MPS gas heater models.
Compatibility
This flame backup sensor is specifically engineered to suit Brivis MPS gas heater models. It matches Brivis Part Numbers 80014886 and B014886. The sensor has a 500mm lead length, which is crucial for proper routing and connection within the appliance.
If you're running a different Brivis model or a non-Brivis heater, always cross-reference part numbers and lead lengths before ordering to ensure a correct fit and safe operation.
Features
- Direct Replacement: Designed as a specific replacement for Brivis ignitor flame backup sensors in MPS models.
- Optimal Length: Features a 500mm lead for straightforward installation and correct positioning.
- Critical Safety Component: Ensures the heater's control system accurately detects flame presence, preventing hazardous unburnt gas release.
- Genuine Part Number Match: Corresponds to Brivis PNs 80014886 and B014886 for assured compatibility.
What's in the Box
- 1x Brivis Gas Heater Flame Backup Sensor (500mm lead)
Using It on the Job
- Safety First: Before starting any work, ensure the main power supply and gas supply to the Brivis heater are completely isolated and locked out.
- Access & Remove: Carefully access the combustion chamber area of the Brivis MPS heater and locate the existing flame sensor. Disconnect its electrical lead and carefully unmount the sensor.
- Install New Sensor: Mount the new 500mm flame backup sensor in the exact position of the old one, ensuring it's correctly aligned to detect the flame. Reconnect the electrical lead securely.
- Test System: Restore gas and power supplies. Run the heater through a full cycle, observing ignition and flame detection to confirm the new sensor is functioning correctly without nuisance lockouts.
- Final Checks: Confirm all access panels are re-secured and conduct any required post-service safety checks according to manufacturer guidelines and Australian standards.
Limitations & Safety Notes
- This part is specific to Brivis MPS gas heater models; it may not be compatible with other heater types or brands.
- Installation and servicing of gas appliances must only be performed by a licensed gas fitter in accordance with AS/NZS 5601 and local regulations.
- Always ensure both electrical and gas supplies are isolated before commencing any work on the appliance.
- Regular maintenance of gas heating systems, including flame sensors, is crucial for safe and efficient operation.
Before you swap out a sensor for a "no-flame" fault, give the old one a good clean with fine emery paper. Sometimes it's just carbon buildup stopping the micro-amp signal, not a failed sensor. Saves a trip to the supplier if you can clean it up.
Pair With
Pair this Brivis flame sensor with our range of Brivis Control Boards and Pressure Switches to keep your heating system fully stocked with essential spares. You might also find our Universal Spares category helpful for general maintenance items.