This Braemar Ignition Module is a crucial component for keeping your ducted gas heater running reliably. It’s built to trigger the ignition sequence, making sure your burner lights up every time it's called for. Over time, these modules can fail, leading to lockout errors and no heat.
Getting heat back into a customer's home, especially during a chilly Australian winter morning, means having the right parts on hand. A genuine replacement like this saves call-backs and keeps everyone happy.
Best For
- Licensed gas fitters and HVAC service technicians.
- Residential ducted gas heating maintenance and repair teams.
- Apprentices learning gas heater diagnostics and component replacement.
Compatibility
This ignition module is a direct replacement part specifically designed for Braemar TB series ducted gas heaters. It's also cross-referenced with Honeywell PN: 4565QD1038B and Seeley PN: 510580. If you're running a different model, check fittings and specs before ordering.
Features
- Genuine Braemar replacement part, ensuring proper fit and function.
- Designed for use with Braemar TB series gas heaters.
- Reliable control of the ignition sequence for consistent burner startup.
- Matches Honeywell and Seeley specifications for this common module.
What's in the Box
- 1 x Braemar Ignition Module (HLS4565QD1038B)
Using It on the Job
- Isolate Power: Always begin by switching off power to the unit at the main switchboard and locking it out. Close the gas isolation valve.
- Access Panel: Remove the appliance's access panel to locate the existing ignition module.
- Disconnect Wiring: Carefully photograph or diagram existing wiring connections before disconnecting. Use a multimeter to confirm no residual voltage.
- Replace Module: Unmount the old module and install the new Braemar ignition module, ensuring all mounting screws are secure.
- Reconnect & Test: Reconnect wiring as per your diagram, open the gas valve, restore power, and initiate a test run of the heater, checking for proper ignition and flame sensing.
- Final Checks: Once confirmed operational, replace the access panel and document the repair.
Limitations & Safety Notes
- Installation and servicing of gas appliances must be performed by a currently licensed gas fitter.
- Always isolate electrical power and gas supply before attempting any work.
- This module is specifically for Braemar TB series heaters. Using it in incompatible units may lead to malfunction or safety hazards.
- Follow all relevant Australian standards and Safe Work guidance during installation.
Tradie Pro Tip: If an ignition module fails, don't just swap it out without investigating. Check the ignitor for cracks, the flame sensor for dirt, and the wiring connections for corrosion. Sometimes, the module is just the symptom, not the root cause.
Pair With
Pair with other essential gas heating spares like new ignitors, flame sensors, and a reliable multimeter for comprehensive diagnostics. A set of basic hand tools for HVAC work will also come in handy.